I’m attempting to flash code over CANBUS on a Nucleo-F446 board, using the instructions from the following application note: [CAN Protocol Used in the STM32 Bootloader](https://www.st.com/resource/en/application_note/cd00264321-can-protocol-used-in-the-stm32-bootloader-stmicroelectronics.pdf). According to the document, […]
Guys I’m trying to implement the SPI in my stm32 Nucleo l476RG without hal drivers. I have have implemented the spi configuration using spi_init function then when it ready for […]
I am using the Arduino IDE to program an STM32 Blue Pill via an ST-Link V2. After following several manuals, I successfully uploaded the blink example to pin C13.Although I […]
Hey guys while developing a CAN bus monitoring system using the ESP32-S3, ESP-IDF, and RTOS, I encountered a WDT (Watchdog Timer) panic within my CAN interrupt service routine (ISR) when […]
Am working on a a home automation system that controls water pumps and taps based on motion detection using the Zephyr RTOS on an ESP32 microcontroller, how can i properly […]
I’m programming an STM32 NUCLEO-F207ZG board and trying to output a PWM signal on pin PE_9 (D6) to drive an LED. I’m using low-level register programming (no HAL/LL drivers). However, […]
Hey guys, I’m using an AVR microcontroller with Zephyr to read data from an ADC via SPI. I’ve configured the SPI peripheral and device tree, but the data coming back […]
Hey guys, a friend of mine is currently working on AT91SAM9M10-EKES. The Code registers IRQ for 2 GPIO pins (PA20 & PA21) but only receives 22/26 expected interrupts (random). Could […]
Hey everyone, I’m currently working on a PCB design involving the DRV8320 and the STM32G431RBT6TR. As you can see in the attached images, I’m trying to minimize the number of […]
GitHub
